(黄铜)内螺纹电动调节阀

(黄铜)进口内螺纹电动调节阀 技术参数 Technical paramete

(黄铜)进口内螺纹电动调节阀结构分为流量调节结构和动态平衡结构两部分  RETZ structure of dynamic balance electric control valve is divided into two parts: flow control structure and dynamic balance structure

流量调节结构可完成阀门流量的设定和调节，配合执行器可实现阀门的电动调节、开关功能 RETZ flow regulating structure can complete the setting and regulation of the valve flow, and cooperate with the actuator to realize the electric regulation and switching functions of the valve

动态平衡结构可实现阀门流量的动态平衡，该结构的核心部件为感压膜片和弹簧，感压膜片感应阀门入口和平衡阀芯内腔之间的压（P1-P2），在此压差作用下调节可变流道的流通面积，保持压差（P1-P2）基本恒定，从而保持流量不变  RETZ dynamic balance structure can realize the dynamic balance of the valve flow. The core components of the structure are the pressure sensing membrane and the spring. The pressure sensing membrane senses the pressure (P1-P2) between the inlet of the valve and the inner cavity of the balance valve core. Under the effect of this pressure difference, the flow area of the variable flow channel is adjusted to keep the pressure difference (P1-P2) basically constant, so as to keep the flow unchanged

结构特性：二通/三通分流/三通合流 Structure: two-way / three-way diversion / three-way confluence

规格说明 Description

流量特性：等百分比  Flow characteristics: equal percentage

阀泄漏率 ：小于KVS值的0~0.04%  Valve leakage rate: less than 0 ~ 0.04% of kVs value

驱动控制∶浮点型，智能型（DC0~10V/4~20mA） Drive control: floating point type, intelligent type (dc0 ~ 10V / 4 ~ 20mA)

执行器防护等级：IP54/65 Protection grade of actuator: IP54/65

工作电源 ：AC24V/AC220V 50/60Hz Working power supply: AC24V / AC220V 50 / 60Hz

输出扭力∶1500N，带断电手动开关功能  Output torque: 1500N，with power-off manual switch function

流量特性

性能特点∶ Performance characteristics

阀体采用阀体无底盖设计，阀杆采用带润滑4层密封保护，使用寿命比普通阀门更长  The valve body is designed with no bottom cover, and the valve stem is protected by 4-layer sealing with lubrication. The service life is longer than that of ordinary valves

驱动器采用全套钢质传动齿轮。同步马达和二个限位浮动式辅助开关具有到位断电功能，实现了对马达的保护和节能作用，控制精度更高，响应速度快，无噪音，使用寿命比普通驱动器更长  RETZ driver adopts a full set of steel transmission gears. The synchronous motor and two limit floating auxiliary switches have the power-off function in place, which realizes the protection and energy-saving function of the motor. The control precision is higher, the response speed is faster, the noise is free, and the service life is longer than that of the ordinary driver

驱动器配有手动调节功能，阀门和驱动器连接采用紧顶螺丝，阀杆卡板连接，方便快速易连接，便于现场安装和调试  The driver is equipped with manual adjustment function. The connection between the valve and the driver is made with set screws and the valve stem clamp plate, which is convenient for quick and easy connection and convenient for on-site installation and commissioning

安装说明 Installation instructions

1.注意阀门介质流向应与管路介质流向一致  Note: the flow direction of valve medium shall be consistent with that of pipeline medium

2.阀门可以安装在供水或回水管路上，一般推荐安装在回水管路上（安装在回水管路上可以使水流控制更为平稳，同时热水回水部分的温度较低，可延长阀门使用寿命），同时推荐在阀门前安装过滤器和止回阀。当介质为蒸汽时，管道上安装排水阀，可以除去凝结水，否则将影响阀门使用寿命  The valve can be installed on the water supply or return pipeline. It is generally recommended to install it on the return pipeline (the installation on the return pipeline can make the water flow control more stable, and the temperature of the hot water return part is low, which can prolong the service life of the valve). At the same time, it is recommended to install a filter and a check valve in front of the valve. When the medium is steam, a drain valve is installed on the pipeline to remove the condensed water, otherwise the service life of the valve will be affected

3.注意阀门安装方向 Pay attention to the installation direction of the valve

介质为蒸汽时，可以任意角度安装介质为冷/热水时，不能向下安装 When the medium is steam, it can be installed at any angle; when the medium is cold / hot water, it cannot be installed downward